BlueTube Audio BT-4 Manual do Operador descarregar pdf (Página 18)

13 - Connecting to Bluetooth®

Connecting to Bluetooth®

Syncing Bluetooth®

1. Turn on amp and allow to warm up before selecting Bluetooth®

input.

2. Enable Bluetooth® on your device. This is usually located in the

“Settings” or “Options” area of your phone.

You may also need to nd the setting that

allows Bluetooth® devices to nd your

phone. Enable this setting.

3. Turn the input selector switch to Bluetooth®.

4. Follow the voice commands.

5. The BlueTube Audio Amplier will show up

as “BT-1A” on your devices menu.

6. You are now ready to listen to audio from

your device via Bluetooth®.

Notes on Using Bluetooth®.

• The BlueTube amp and your device should remember each other.

As long as your device’s Bluetooth® is still on, it should auto connect

to the BlueTube Audio Amplier.

• After a period of no connection, the Bluetooth® module will power

down. Move the selector knob from Bluetooth® to Aux 2 then back

to Bluetooth® to reconnect.

• Bluetooth® on any amp especially a vacuum tube amp is a

convenience. It does not and never will deliver the best audio

quality. For convenience you can use the Bluetooth® module,

however, for the best quality use the Aux 1 and Aux 2 inputs.

Bluetooth® must compress your audio, send it over the airwaves,

then uncompress it again. This will result in deterioration of audio

quality.

• Bluetooth® audio uses RF to transmit the audio. Being encased in

a vacuum tube amplier could result in some noise being picked up

from the high voltage transformers. This will usually only be noticed

at very low volumes.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Sem comentários

BlueTube Audio BT-4 Manual do Operador Página 18